CYBEX Sirona M - Rear-Facing Installation Using LATCH; Preparing LATCH Straps for Rear-Facing; Connecting LATCH Anchors (Rear-Facing)

1. Locate the LATCH Connector Storage compartment. See LATCH Storage
on page 15. Remove LATCH Straps. Route the LATCH Straps out through
the Forward-Facing Belt Path openings. Make sure LATCH Adjuster Strap is
loosened to its full length.
2. Place Child Restraint rear-facing on selected vehicle seat. Make sure it is not
blocking the vehicle belt buckle.
3. If LATCH Strap is in the Forward-Facing Belt Path, grab both ends of LATCH
Strap. Slide LATCH Strap to blue REAR-FACING opening on both sides.
Note: LATCH Strap must be loosened to its full length in order to slide LATCH
Strap into position.
4. Lower Seat Cover and adjust Headrest to proper height for your child.
Place LATCH Strap here.
3433
1
1
2
3
4
5
6
7
8
9
10
3
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
4
INSTALL REAR-FACING USING LATCH INSTALL REAR-FACING USING LATCH
EN
REAR-FACING