CYBEX Sirona M User Manual

4. Place Child Restraint forward-facing on selected vehicle seat. Make sure it is
not blocking the vehicle belt buckle.
5. Installation on a Level Ground: Locate the Level Indicator label and
readjust the seat recline to any position that the ball falls within the red zone for
FORWARD-FACING installation.
6. Installation on a Slope: If the vehicle is on a slope adjust the seat recline to
position 9 or 10 only.
Installation Options:
*LATCH installation
continued on page 43.
*Lap/Shoulder Belt installation
continued on page 47.
*Lap Belt Only installation
continued on page 49.
When installing this Child Restraint with lower LATCH Connectors OR the vehicle
seat belt, always use the Tether, if a tether anchor is available.
A tether reduces movement of a forward-facing Child Restraint in a crash and
helps to achieve a tight installation. Tether anchor locations vary from vehicle
to vehicle. Refer to your vehicle owner's manual for exact locations, anchor
identication, and requirements.
1. IF TETHER ANCHOR IS AVAILABLE IN YOUR VEHICLE - Before placing the
Child Restraint in the vehicle, remove Tether from the Tether Compartment. If a
Tether anchor is not available, the Tether should be stored properly.
2. Make sure the vehicle is on level ground, if possible.
3. Squeeze the Recline Adjustment Handle
a
on front of Child Restraint and push
back to adjust so the Child Restraint seat back is aligned with the vehicle seat
back
b
. Only use recline positions 5 through 10 for forward-facing use.
4241
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
3
10
9
8
7
6
5
4
3
2
1
4
6
5
a
b
FORWARD-FACING SETUPFORWARD-FACING SETUP
EN
FORWARD-FACING

CYBEX Sirona M Specifications

General

Model	Sirona M
Category	Convertible Car Seat
Forward-Facing Weight Limit	22-65 lbs
Installation Type	LATCH or Vehicle Seat Belt
Orientation	Rear-Facing and Forward-Facing
Harness Type	5-point harness
Warranty	2 years
Height Limit	Up to 49 inches
Safety Features	energy-absorbing shell
Adjustable Headrest	Yes, 12-position