CHECK YOUR WORK
• HOLD Child Restraint at each side near Forward-Facing Belt Paths. Pull side to
side and forward. Child Restraint should not move more than 1 in. (2.5 cm) from
vehicle seat back or side-to-side.
• Make sure ball is in red zone for forward-facing use (p. 41-42). If
necessary, loosen the LATCH and Tether Straps, readjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
• Check installation before every use.
6. Locate Tether anchor in your vehicle. Attach Tether Hook. Pull Tether Adjuster
Strap to tighten.
4. Locate the lower LATCH anchor bars in your vehicle. Attach both LATCH
Connectors to the vehicle lower LATCH anchor bars.
5. While pushing down on the Child Restraint, pull up on the end of the LATCH
Adjuster Strap until strap is tight using adjuster on either side of the Child
Restraint.
Note: Pull the end of the LATCH Adjuster Strap by reaching through the
Forward-Facing Belt Path
a
on the inside of the Child Restraint.
4645
To Next Page
Loading...
Need help?
General
