interference that may cause undesired operation of the device.
cause interference, and (2) This device must accept any interference, including
SensorSafe
™
Technology
Questions? Comments?:
Visit us at: http://cybex-online.com/us/contact.html
Or call CYBEX at: 1-877-242-5676
This device meets the requirements of SAE J3005.
FCC Certied:
Chest Clip Model: SOSR2, FCC ID: 2ABS2-SOSR2 (IC ID: 11740A-SOSR2)
Dongle Model: SS2, FCC ID: 2ABS2-SS2 (IC ID: 11740A-SS2)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
WARNING!
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
6261
GENERAL INFORMATION ABOUT SENSORSAFE GENERAL INFORMATION ABOUT SENSORSAFE
EN
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
To Next Page
Loading...
Need help?
General
