3. CYCLE THE SENSORSAFE CHEST CLIP.
Your SensorSafe Chest Clip is designed to “go to sleep”
if clipped for more than 12 hours. The chest clip will
“wake up” or reset by simply opening and closing.
TO PRESERVE BATTERY LIFE, ALWAYS STORE THE
SENSORSAFE CHEST CLIP IN THE UN-CLIPPED
POSITION.
4. DRIVE THE VEHICLE.
The SensorSafe Receiver is designed to respond after the vehicle has been driven
at 5 miles per hour or more.
5. PARK THE VEHICLE AND TURN OFF THE IGNITION.
Within 2 seconds of parking your vehicle and turning off the ignition you will hear
the SensorSafe reminder, alerting you that your baby is in the vehicle.
If you don’t hear the reminder tone, test your SensorSafe by following steps 1-5
again. Contact CYBEX at: 1-877-242-5676 or online at:
http://cybex-online.com/us/contact.html if the reminder tone again fails to sound.
Note: SensorSafe Receiver will also alarm if your child un-clips the Chest Clip
after the vehicle has been driven at 5 miles per hour or more, but only if the
vehicle is on.
REPLACING THE SENSORSAFE CHEST CLIP BATTERY.
1. Loosen Harness by pressing Harness Release Button on the front of the Child
Restraint and pulling forward on both Harness Straps.
2. Unbuckle Harness by pressing the button on the Crotch Buckle and pulling out
both Buckle Tongues.
3. Open Chest Clip by pressing the Release Button and pulling the Chest Clip
apart.
6665
A
R
M
P
I
T
L
E
V
E
L
1
2
10
9
8
7
6
5
4
3
A
R
M
P
I
T
L
E
V
E
L
A
R
M
P
I
T
L
E
V
E
L
A
R
M
P
I
T
L
E
V
E
L
1
2
3
USING SENSORSAFE USING SENSORSAFE
EN
To Next Page
Loading...
Need help?
General
