To illustrate the PIN over-ride procedure we will assume a PIN of
4,3,2,1.
If indicators are still flashing, turn the ignition on and allow the
system to reset with all doors closed.
Turn ignition switch to ON position, the status LED will remain lit.
Turn ignition switch to the ACC position and count the LED
flashes.
Turn ignition switch ON when the 4th flash has extinguished.
Turn back to ACC position and count 3 flashes, switch ignition ON.
Turn back to ACC position and count 2 flashes, switch ignition ON.
Turn back to ACC position and count 1 flash, switch ignition ON.
When all four digits have been entered correctly, the car’s indicators
will flash once to confirm that the immobiliser is disarmed. The
engine can be started and the car driven. The automatic arming
feature will ensure car is secured again if the ignition is left off for
more than 40 seconds.
•
•
•
•
•
•
To Next Page
Loading...