-16-
will be confirmed by two indicator flashes.
Enter the remaining digits in the same fashion. Four flashes will
confirm the programming procedure is complete.
Arm the system and confirm the new PIN by completing override
procedure. Ensure the new PIN is recorded, but do not leave these
details in the vehicle.
BATTERY REPLACEMENT
Use a flat head screwdriver to carefully separate the two body
pieces taking care not to disturb the circuit board. Remove the
old batteries whilst paying attention to the orientation of the
positive and negative terminals. Insert
new batteries in identical fashion to the
original and re-assemble remote. Test
remote control by pressing main button.
For further information, please contact
your local Cyclops service centre. Remote
battery type is CR2016.
•
To Next Page
Loading...