PROBLEM SOLVING
System won’t arm. LED on dash won’t flash.
Make sure that ignition switch is in the OFF position.
Ensure the vehicle battery is not flat.
Try your spare remote transmitter unit.
System won’t disarm. LED on dash won’t extinguish.
Try spare remote control.
Use Emergency PIN to override system and contact nearest
Cyclops service centre.
The remote fails to operate
If the remote fails to operate and the LED does not light
up when the button is pressed then change the battery.
To do this you will need a small screwdriver. See battery
replacement procedure.
•
•
•
•
•
•
•
•
•
-18-
To Next Page
Loading...