Quick Start Guide
After unboxing and installing your CYC motor system, there are two main things you need to set up.
1. Change your Battery No. settings according to your rated voltage.
Within 15 seconds of turning on your display, long press the MENU button to enter the settings functions.
Press UP/DOWN to navigate the settings page & MENU to select.
Please note that 6s to 9s is not compatible with the CYC systems. This will be removed in future batches. Our
aplogies for the confusion.
2. Change your Wheel settings according to your bike’s wheel size.
3. Now, you can set things up like your temperature and speed unit as well as your brightness level.
Otherwise you’re good to go!
6s = 22.2 V
7s = 25.9V
8s = 29.6V
9s = 33.3 V
10s = 36V
11s = 40.7V
12s = 44.4 V
13s = 48V
14s = 52V
Functionalities
Power On/ O
Press and hold the POWER button for 3 seconds to turn the display on/ o.
Navigation
The MENU button is used to go into your main settings page & your clear data page. It is also used to
enter and select a setting or function.
1. POWER
2. MENU
3. UP
4. DOWN
Switch Dashboard
Switch the main dashboard to display dierent information by pressing the MENU button.
DS103 DISPLAY GUIDE
06
39
To Next Page
Loading...