6.8 Telnet Control
Before attempting to use the telnet control, please ensure that both the
Matrix (via the 'CONTROL' port) and the PC/Laptop are connected to the
active networks.
To access the telnet control in Windows 7, click on the 'Start' menu and
type "cmd" in the Search eld then press enter
Under Windows XP go to the 'Start' menu and click on "Run", type "cmd"
with then press enter.
Under Mac OS X, go to Go
→
Applications
→
Utilities
→
Terminal See below
for reference.
Once in the command line interface (CLI) type "telnet", then the IP address
of the unit and "23", then hit enter.
Note: The IP address of the Matrix can be displayed on the device's LCM
monitor by pressing the Menu button twice.
To Next Page
Loading...
