Cypress EZ-USB FX3 SDK - Page 50

Cypress EZ-USB® FX3™ SDK Quick Start Guide, Version 1.3.1 50
In the CX3 Configuration Model Creation Wizard dialog box which comes up,
select the parent folder for the project, enter a name for the CX3 configuration
file, and click on Finish to generate the CX3 configuration file.
2. CX3 Receiver Configuration Tool
A new CX3 Configuration file (with a .cycx extension) will get created under the
selected project and the file will be opened up in the CX3 Receiver
Configuration Tool as shown below.
The file can also be opened by clicking on the cycx file in the project explorer.
Any unsaved changes on the configuration file will be indicated by the * mark on
the window title. The CX3 configuration file (with .cycx extension) can be saved
by Clicking on the Save or Save All buttons.
Figure 7-5: Saving the CX3 Configuration File
3. Creating a configuration
The first step in creating the configuration is to set the Configuration name and
Description. The configuration name is used as the name of the structure object
that is generated and should therefore follow the naming conventions for C/C++
variables. The description is provided as a comment for the structure object and
therefore should not contain „/*‟ or „*/‟.
Figure 7-6: Configuration Name Selection
4. Configure the MIPI CSI-2 Inputs
The MIPI CSI-2 inputs section should be configured to match the Image
Sensor‟s output parameters.