Cyrus Pre - Installation

Cyrus Pre CAUTIONS
3
English
Your Cyrus Pre is factory set to operate from a fixed
mains supply voltage, which is marked on a label at the
rear of the unit. Before connecting, check that this voltage
is the same as your mains supply, i.e.
230V Products Voltage Range 220V-240V
115V Products Voltage Range 110V-120V
Always follow the instruction handbook and retain it in a
safe place for future reference.
Before proceeding with installing the Cyrus Pre, ensure
that the following items are included in the accessory box:
•
Instruction Manual (Cyrus Pre)
•
Instruction Manual (Cyrus System Commander)
•
Power Cable
•
Cyrus System Commander
•
RCA Output Interconnect cable
•
Guarantee Card
After removing these items, please retain the packing for
future use.
Install the Cyrus Pre in a well ventilated location where it
will not be exposed to high temperature or humidity.
Avoid installing the Cyrus Pre in a location which is
exposed to direct rays of the sun, or near to hot appliances
or radiators. Placing and using the pre-amplifier for long
periods on heat-generating sources will affect
performance and may damage the cabinet. Installation in a
damp or dusty environment may result in malfunction or
accident.
The Cyrus Pre is supplied ready for use in your location.
Care has been taken to ensure that the power supply
requirements are correctly set. Consult your Mission
distributor to arrange for conversion of your Cyrus Pre
should you move to another area with a different mains
supply voltage.
It is important not to allow any liquid or foreign object fall
into this unit. When routing the power cord avoid running
it over or near sharp objects.
If the amplifier is not to be used for a long period of time,
unplug the unit from the mains power supply.
This unit contains no user serviceable parts, therefore
never
remove any panels from the unit or attempt to
service the unit. In the unlikely event of failure, please
refer to qualified service personnel.
UNPACKING
LOCATION
RE-LOCATING
PRECAUTIONS REGARDING INSTALLATION