19
LCD SCREEN cont.
MESSAGE MEANING / ACTION
LOW BATTERY
THIS MESSAGE WILL SHOW AFTER INITIAL START UP, IF
THE LOW BATTERY MESSAGE REMAINS AFTER THE
OPERATOR IS TRIGGERED,CHECK BATTERY VOLTAGE /
CHECK CHARGER VOLTAGE
MAINS FAIL
CHECK THE MAINS POWER / CHECK TRANSFORMER /
CHECK CHARGER.
GATE CLOSED THE GATE IS IN THE CLOSED POSITION.
GATE OPEN THE GATE IS IN THE OPEN POSITION.
OBSTRUCTION
THE GATE HAS SENSED AN OBSTRUCTION. CHECK THE
WHEELS / ROLLERS/ RACK/ BRACKETS/ FUSES/ FORCE
SETTING POTS.
AUTO-CLOSE ACTIVE THE GATE IS SET TO AUTO CLOSE.
PARTY MODE THE GATE IS IN AUTO-CLOSE OVERRIDE .
PROGRAM MODE THE GATE IS IN PROGRAM MODE.
PROGRAMMING CLOSE POSTION THE GATE IS CLOSING WHILE PROGRAMMING.
BEAMS AC MODE THE BEAMS AUTO CLOSE MODE IS ACTIVE
PROGRAMMING OPEN POSITION THE GATE IS OPENING WHILE PROGRAMMING.
PROGRAMMING COMPLETE PUT
SWITCH 1 OFF
THE PROGRAM IS COMPLETE.
SERVICE DUE THE OPERATOR REQUIRES A SERVICE.
NO REV PULSES
FAULTY REV COUNTER, PC BOARD MOUNTING MAY BE
LOOSE, REV COUNTER MAGNET HOLDER IS BROKEN.
BEAMS BLOCKED
THE INFRARED SAFETY BEAMS ARE BLOCKED /
FAULTY/ THE BEAMS DIPSWITCH IS OFF.
MARKER OK
INDICATES WHEN THE MAGNET ON THE GATE IS
SENSED BY THE MARKER.
Some of the messages below have been shortened
to show the main message. Certain messages will
also show the action needed.
LCD Screen
To Next Page
Loading...
Need help?
General