Using the Configuration Utility in Router Mode (continued)
Tools > Admin
At this page, the DWL-G730AP administrator can change the system password. There
are two accounts that can access the router’s Web-management interface. They are
admin and user. Admin has read/write access while user has read-only access. The
user can only view the settings but cannot make any changes.
Remote Management- Remote management allows the DWL-G730AP to be
configured from the Internet by a Web browser. A username and password is still required
to access the Web-management interface. In general, only a member of your network
can browse the built-in Web pages to perform Administrator tasks. This feature enables
you to perform Administrator tasks from the remote (Internet) host.
IP Address- The Internet IP address of the computer that has access to the router.
If you input an asterisk (*) into this field, then any computer will be able to access the
router. Putting an asterisk (*) into this field would present a security risk and is not
recommended.
Port- The port number used to access the router.
Example- http://x.x.x.x:8080 where x.x.x.x is the WAN IP address of the router and
8080 is the port used for the Web-mangement interface.
Administrator-
Password-
admin is the Administrator login name
Enter the password and enter again to confirm
User-
Password-
user is the User login name
Enter the password and enter again to confirm
To Next Page
Loading...
