42D-Link DAP-1950 User Manual
Section 4 - Wi-Fi Mesh Setup
Step 1
Connect and plug in the DAP-1950 close to your Wi-Fi Mesh router and wait
for the LED light to blink orange.
Step 2
Use the Ethernet cable to connect the DAP-1950 to one of the LAN ports on
the Wi-Fi Mesh router. The pairing process may take a few minutes. The status
and the signal indicator LEDs on the DAP-1950 will turn solid green once it
has nished pairing with your Wi-Fi Mesh router.
Step 3
Disconnect the Ethernet cable and place the Wi-Fi Mesh compatible device
anywhere in your home to extend your home Wi-Fi.
< 1 m
Setup Using an Ethernet Cable
To Next Page
Loading...
