47D-Link DAP-1950 User Manual
Section 6 - Troubleshooting
• Congure your Internet settings:
• Go to the Control Panel. Search for Internet Options. From the Security tab, click the button to restore the settings to their defaults.
• Click the Connection tab and set the dial-up option to Never Dial a Connection. Click the LAN Settings button. Make sure nothing
is checked. Click OK.
• Go to the Advanced tab and click the button to restore these settings to their defaults. Click OK three times.
• Close your web browser (if open) and open it.
• Access the web management interface. Open your web browser and enter the address of your extender
(http://dlinkapXXXX.local) in the address bar. This should open the login page for your web management. If the DAP-1950 is not
connected to an uplink router, you can try accessing the web interface using the default IP address http://192.168.0.50.
• If you still cannot access the conguration, unplug the extender from the power outlet for at least 10 seconds and plug it back
in. Wait about 30 seconds and try accessing the conguration. If you have multiple computers, try connecting using a dierent
computer.
2. What can I do if I forgot my password?
If you forgot your password, you must reset your extender. Unfortunately this process will change all your settings back to the
factory defaults.
To reset the extender, locate the reset button (hole) on the underside panel of the unit. With the extender powered on, use a
paperclip to hold the button down . Release the button and the extender will go through its reboot process (indicated by the LED
turning red). Wait about 30 seconds to access the extender. The default IP address is
http://dlinkapXXXX.local. When logging in, the username is admin and the password is password.
To Next Page
Loading...
