D-Link DAP-1955 - Wireless Setup Wizard

16D-Link DAP-1955 User Manual
Section 3 - Conguration
Wireless Setup Wizard
How do I access the web-based conguration utility?
To access the web-based conguration utility, connect to the device’s network
using an Ethernet cable or by using its Wi-Fi Name/SSID and password, then
type the device specic URL into a browser. The device specic URL is written
in the format of http://dlinkap<WXYZ>.local./ where <WXYZ> changes per
the device and is located on the device’s label.
If this is your rst time logging in to the extender and no connection has been
established, the setup wizard will automatically appear. If the setup process was
not previously completed, then log in to the interface by leaving the password
eld blank.
The setup wizard is designed to guide you through a step-by-step process to congure your new DAP-1955
AC1900 Mesh Wi-Fi Range Extender to extend your wireless network and connect to the Internet via a wireless setup process. To set
your DAP-1955 using an Ethernet cable, please refer to “Access Point Mode Settings” on page 23.