8
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on the bottom of
the DCS-2102/2121 and attach it to your network switch or router.
Connect the Power Adapter
Attach the power adapter to the power jack located on the bottom of the DCS-2102/2121 and
connect the power adapter to a power outlet. After connecting the power adapter, you should
see the Status LED on the front of the camera turn on.
The Status LED will light red when it receives power, will light green after the camera connects
to the network, and will flash green when the camera is being accessed.
To Next Page
Loading...
Need help?
General
