37
MAINTENANCE > Backup and Restore
This screen llows you to save and restore the camera’s current configuration. You can also
reset all settings to factory default, and reboot the device.
Save To Local Hard Drive: Click on the Save Configuration button to save the current
configuration to a hard drive.
Load From Local Hard Drive: To load a saved configuration, click on the Browse… button
to select a configuration file from your hard drive, then click
the Load Configuration button to load the new
configuration.
Restore To Factory Defaults: Clicking this button will reset all settings to their factory
defaults. If you choose to reset your settings, you will need to
set up your camera again.
Reboot Device: Clicking the Reboot button will reboot your device
To Next Page
Loading...
Need help?
General
