49D-Link DCS-910 User Manual
Section 4 - Security
Run the Setup Wizard program from the CD included with the DCS-910. Follow the steps in the Quick Installation Guide to
configure the DCS-910. The camera will be assigned a local IP Address that allows it to be recognized by the router. Write
down this IP Address for future reference.
1 Assign a Local IP Address to Your Camera
After you have completed the setup of the DCS-910 outlined in the Quick Installation Guide you will have an operating camera
that has an assigned IP Address. Because you are using a router to share the Internet with one or more PCs, the IP Address
assigned to the Internet Camera will be a local IP Address. This allows viewing within your Local Area Network (LAN) until the
router is configured to allow remote viewing of the camera over the Internet.
This is the IP Address assigned to your camera (192.168.0.120 is only an example). You will probably have a different IP Address.
To Next Page
Loading...
Need help?
General
