10/100 Fast Ethernet Switch User’s Guide
Unpacking and Setup
11
LED Indicators
After the switch is turned on, the LED indicators should respond as follows:
♦
All of the LED indicators will blink momentarily. This blinking of
the LED indicators represents a reset of the system.
♦
The power LED indicator will remain ON.
Power Failure
As a precaution, the Switch should be turned
OFF
in case of a power
failure. Press the power switch to the off or “0” position. When power is
resumed, turn the Switch
ON
. At all times, avoid leaving the Switch ON if
a power failure is anticipated.
To Next Page