D-Link DES-3052P - Page 113

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
108
show cos port_mapping
Purpose Used to map the destination MAC address in incoming packets to
one of the hardware queues available on the switch.
Syntax
show cos port_mapping {port <portlist>}
Description The show cos mac_mapping command is used to view map static
destination MAC addresses to one of the CoS traffic classes.
Parameters
<portlist>  Specifies a port or range of ports to be configured.
If no parameter is specified, all port-to-class mappings will be
shown.
Restrictions None.
Example usage:
To show the cos port_mapping of the port 3:
DES-3028P:4# show cos port_mapping port 3
Command: show cos port_mapping port 3
Port Priority
------------------
3 3
DES-3028P:4#
config cos mac_mapping
Purpose Used to map the destination MAC address in incoming packet to
one of the hardware queues available on the switch.
Syntax
config cos mac_mapping destination_addr <macaddr> [class
<class_id 0-3>]
Description The config cos mac_mapping command is used to map static
destination MAC address to one of the traffic classes.
Parameters
destination_addr  The MAC address to be configured.
<class_id 0-3>  The number of the Switch’s hardware priority
queue. The Switch has four hardware priority queues available.
They are numbered between 0 (the lowest priority) and 3 (the
highest priority).
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the destination MAC address 00-01-02-03-04-05 to traffic class 2 mapping:
DES-3028P:4# config cos mac_mapping destination_addr 00-01-02-03-
04-05 class 2
Command: config cos mac_mapping destination_addr 00-01-02-03-04-
05 class 2
Success.
DES-3028P:4#