D-Link DES-3052P - Igmp Snooping Commands

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
130
19
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config igmp_snooping [ vlan_name <vlan_name 32> |all] { host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-16711450> | state
[enable|disable] | fast_leave [enable|disable]}
config igmp_snooping querier [vlan_name <vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_member_query_interval <sec 1-25> | state [enable | disable]}
config router_ports <vlan_name 32> [add | delete] <portlist>
config router_port_forbidden <vlan_name 32> [add | delete] <portlist>
enable igmp snooping {forward_mcrouter_only}
show igmp snooping {vlan <vlan_name 32> }
disable igmp snooping {forward_mcrouter_only}
show router ports {vlan <vlan_name 32>} {[static | dynamic | forbidden]}
show igmp_snooping group {vlan <vlan_name 32>} {data_driven}
config igmp snooping
data_driven_learning
[ vlan_name <vlan_name 32> |all] { aged_out [enable|disable]}
config igmp_snooping
data_driven_learning
max_learned_entry
<value 1-256>
clear igmp snooping data_
driven _group
[ vlan_name <vlan_name 32> | all ]
config igmp
access_authentication
ports [all|<portlist>] state [enable|disable]
show igmp
access_authentication
ports [all|<portlist>]
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose Used to configure IGMP snooping on the Switch.
Syntax
[ vlan_name <vlan_name 32> |all] { host_timeout <sec 1-16711450> | route
r_timeout <sec 1-16711450> | leave_timer <sec 1-16711450> | state
[enable|disable] | fast_leave [enable|disable]}
Description
This command allows the user to configure IGMP snooping on the Switch.
Parameters
<vlan_name 32>  The name of the VLAN for which IGMP snooping is to be
configured.
host_timeout <sec 1-16711450>  Specifies the maximum amount of time a host
can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout <sec 1-16711450>  Specifies the maximum amount of time a
route can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.