D-Link DES-3052P - Lldp Commands

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
292
43
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
enable lldp
disable lldp
config lldp
message_tx_interval
<sec 5 - 32768 >
config lldp
message_tx_hold_multiplier
< int 2 - 10 >
config lldp tx_delay < sec 1 - 8192 >
config lldp reinit_delay < sec 1 - 10 >
config lldp
notification_interval
<sec 5 - 3600 >
config lldp ports [<portlist>|all] notification [enable | disable]
config lldp ports [<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx |
disable]
config lldp ports [<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
config lldp ports [<portlist>|all] basic_tlvs [all | {port_description |
system_name | system_description | system_capabilities}]
[enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_pvid [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name
32> ] | vlanid <vidlist> ] [enable | disable]
config lldp ports [<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp
| gvrp | stp }] [enable | disable]
config lldp ports config lldp ports [<portlist>|all] dot3_tlvs [all |
{mac_phy_configuration_status | link aggregation |
power_via_mdi | maximum_frame_size}] [enable | disable]
config lldp
forward_message
[enable | disable]
show lldp
show lldp mgt_addr {ipv4 <ipaddr>}
show lldp ports {<portlist>}
show lldp local_ports { <portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports {<portlist>}