D-Link DES-3052P - Limited Ip Multicast Address Commands

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
287
42
LIMITED IP MULTICAST ADDRESS COMMANDS
The Limited IP Multicast Address command allows the administrator to permit or deny access to a port or range of ports by
specifying a range of multicast addresses. The limited IP multicast address commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
create mcast_filter_profile profile_id <value 1-24> profile_name <name 1-32>
config mcast_filter_profile
[profile_id < value 1-24>| profile_name <name 1-32> ] {
profile_name <name 1-32> | [add | delete ]
<mcast_address_list>}
delete mcast_filter_profile [profile_id [<value 1-24> | all]
delete mcast_filter_profile profile_name <name 1-32>
show mcast_filter_profile { [profile_id <value 1-24>|profile_name <name 1-32>]}
config limited_multicast_addr ports <portlist> {[add | delete ] [profile_id <value 1-24> |
profile_name <name 1-32> ] }
show limited_multicast_addr ports {<portlist>}
config max_mcast_group port <portlist> max_group [<value 1-256>]
show max_mcast_group ports { <portlist>}
Each command is listed, in detail, in the following sections.
create mcast_filter_profile profile_id
Purpose This command creates a multicast address profile.
Syntax
create mcast_filter_profile profile_id <value 1-24> profile_name
<name 1-32>
Description This command creates a multicast address profile. Multiple ranges of
multicast addresses can be defined in the profile.
Parameters
profile_id  ID of the profile. Range is 1 to 24.
profile_name  Provides a meaningful description for the profile
Restrictions Only Administrator-level users can issue this command.
Example usage:
To create an mcast filter profile:
DES-3028P:4# create mcast
_
filter
_
profile profile
_
id 2
profile_name MOD
Command: create mcast
_
filter
_
profile profile
_
id 2 profile
_
name
MOD
Success.
DES-3028P:4#