DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
293
Each command is listed, in detail, in the following sections.
enable lldp
Purpose Used to enable LLDP operations on the switch.
Syntax
enable lldp
Description This is a global control for the LLDP function.
When this function is enabled, the switch can start to transmit LLDP
packets and receive and process the LLDP packets.
The specific function of each port will depend on the per port LLDP
setting. For the advertisement of LLDP packets, the switch announces
the information to its neighbor through ports. For the receiving of LLDP
packets, the switch will learn the information from the LLDP packets
advertised from the neighbor in the neighbor table.
The default state for LLDP is disabled.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage
To enable LLDP:
DES-3028P:4# enable lldp
Command: enable lldp
Success.
DES-3028P:4#
disable lldp
Purpose Used to disable LLDP operation on the switch.
Syntax
disable lldp
Description The switch will stop sending and receiving of LLDP advertisement
packets.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage
To disable LLDP:
DES-3028P:4# disable lldp
Command: disable lldp
Success.
DES-3028P:4#
config lldp message_tx_interval
Purpose Used to change the packet transmission interval.
Syntax
config lldp message_tx_interval <sec 5 - 32768 >
Description This interval controls how often active ports retransmit advertisements to
their neighbors.
Parameters
message_tx_interval Changes the interval between consecutive
To Next Page
Loading...
