D-Link DES-3052P - Page 124

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
119
config gvrp
ingress_checking [enable | disable]  Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
by the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To set the ingress checking status, the sending and receiving GVRP information:
DES-3028P:4#config gvrp 1-
4
state enable ingress
_
checking
enable acceptable_frame tagged_only pvid 2
Command: config gvrp 1-
4
state enable ingress
_
checking
enable acceptable_frame tagged_only pvid 2
Success.
DES-3028P:4#
enable gvrp
Purpose Used to enable GVRP on the Switch.
Syntax
enable gvrp
Description This command, along with disable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP configuration
on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3028P:4#enable gvrp
Command: enable gvrp
Success.
DES-3028P:4#
disable gvrp
Purpose Used to disable GVRP on the Switch.
Syntax
disable gvrp
Description This command, along with enable gvrp, is used to enable and
disable GVRP on the Switch, without changing the GVRP
configuration on the Switch.
Parameters None.