D-Link DES-3052P - Page 158

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
153
17 ForceAuth Success Authorized
18 ForceAuth Success Authorized
19 ForceAuth Success Authorized
20 ForceAuth Success Authorized
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_mode
Purpose Used to configure the 802.1X authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x auth_mode command is used to enable either
the port-based or Host-based 802.1X authentication feature on the
Switch.
Parameters
[port_based | mac_based]  The Switch allows users to authenticate
802.1X by either port or MAC address.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure 802.1X authentication by MAC address:
DES-3028P:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3028P:4#
config 802.1x capability ports
Purpose Used to configure the 802.1X capability of a range of ports on the
Switch.
Syntax
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
Description The config 802.1x command has two capabilities that can be set for
each port, authenticator and none.
Parameters
<portlist>  Specifies a port or range of ports to be configured.
all  Specifies all of the ports on the Switch.
authenticator  A user must pass the authentication process to gain
access to the network.
none  The port is not controlled by the 802.1X functions.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure 802.1X capability on ports 1-10:
DES-3028P:4#config 802.1x capability ports 1–10
authenticator
Command: config 802.1x capability ports 1–10
authenticator
Success.