DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
11
create account
Purpose Used to create user accounts.
Syntax
create [admin | user] <username 15>
Description The create account command is used to create user accounts that
consist of a username of 1 to 15 characters and a password of 0 to
15 characters. Up to 8 user accounts can be created.
Parameters
admin <username>
user <username>
Restrictions Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
Example usage:
To create an administrator-level user account with the username “dlink”.
DES-3028P:4#create account admin dlink
Command: create account admin dlink
Enter a case-sensitive new password:****
Enter the new password again for
confirmation:****
Success.
DES-3028P:4#
NOTICE: In the case of lost passwords or password corruption, please refer to
Appendix C Password Recovery Procedure, at the end of this manual which
will guide you through the steps necessary to resolve this issue.
config account
Purpose Used to configure user accounts
Syntax
config account <username>
Description The config account command configures a user account that has
been created using the create account command.
Parameters
<username>
Restrictions Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
Example usage:
To configure the user password of “dlink” account:
To Next Page
Loading...
