D-Link DES-3052P - Page 198

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
193
config dst
e_time  Configure the time of day to end DST.
 <end_time hh:mm>  Time is expressed using a 24-hour clock, in
hours and minutes.
s_date  Configure the specific date (day of the month) to begin DST.
 <start_date 1-31>  The start date is expressed numerically.
e_date  Configure the specific date (day of the month) to begin DST.
 <end_date 1-31>  The end date is expressed numerically.
offset [30 | 60 | 90 | 120]  Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30,60,90,120. The
default value is 60
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch:
DES-3028P:4#config dst repeating s
_
week 2 s
_
day tue
s
_
mth 4 s
_
time 15:00 e
_
week 2 e
_
day wed e
_
mth 10 e
_
time
15:30 offset 30
Command: config dst repeating s
_
week 2 s
_
day tue s
_
mth
4 s_time 15:00 e
_
week 2 e
_
day wed e
_
mth 10 e
_
time 15:30
offset 30
Success.
DES-3028P:4#
show time
Purpose Used to display the current time settings and status.
Syntax
show time
Description This will display system time and date configuration as well as
display current system time.
Parameters None.
Restrictions None.
Example usage:
To show the time currently set on the Switch’s System clock: