D-Link DES-3052P - Page 224

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
219
DES-3028P:4#config authen serv
e
r
_
host 10.1.1.121
protocol tacacs+ port 4321 timeout 12 retransmit 4
Command: config authen server
_
host 10.1.1.121 protocol
tacacs+ port 4321 timeout 12 retransmit 4
Success.
DES-3028P:4#
delete authen server_host
Purpose Used to delete a user-defined authentication server host.
Syntax
delete authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
Description This command is used to delete a user-defined authentication
server host previously created on the Switch.
Parameters
server_host <ipaddr>  The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host the user wishes to
delete. The user may choose one of the following:
 tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
 xtacacs  Enter this parameter if the server host utilizes
the XTACACS protocol.
 tacacs+  Enter this parameter if the server host utilizes
the TACACS+ protocol.
 radius  Enter this parameter if the server host utilizes the
RADIUS protocol.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete a user-defined TACACS+ authentication server host:
DES-3028P:4#delete authen server
_
host 10.1.1.121 protocol
tacacs+
Command: delete authen server_host 10.1.1.12
1
protocol
tacacs+
Success.
DES-3028P:4#
show authen server_host
Purpose Used to view a user-defined authentication server host.
Syntax
show authen server_host
Description This command is used to view user-defined authentication server
hosts previously created on the Switch.
The following parameters are displayed:
IP Address – The IP address of the authentication server host.
Protocol – The protocol used by the server host. Possible results will
include TACACS, XTACACS, TACACS+ or RADIUS.
Port – The virtual port number on the server host. The default value is