DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
19
save
Syntax
save {[config|log|all]}
Description This command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch’s memory each time the Switch is restarted.
Parameters config – Used to save the current configuration to a file.
log – Used to save the current log to a file. The log file cannot be
deleted.
all – Save changes to currently activated configurations and save
log. If no keywords are specified, save the changes to the
configuration. If there are no keywords specified, the changes will be
saved to the configuration.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DES-3028P:4#save
Command: save
Saving all configurations to NV-RAM... Done.
Success.
DES-3028P:4#
reboot
Purpose Used to restart the Switch.
Syntax
reboot
Description This command is used to restart the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To restart the Switch:
DES-3028P:4#reboot
Command: reboot
Are users sure want to proceed with the system reboot? (y|n)
Please wait, the switch is rebooting...
reboot force_agree
Purpose Used to force the Switch to restart.
Syntax
reboot force_agree
Description This command is used to force the Switch to restart.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To Next Page
Loading...
