D-Link DES-3052P - Page 256

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
251
The SMTP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
enable smtp
disable smtp
config smtp {server <ipaddr> | server_port <tcp_port_number 1-65535> |
self_mail_addr <mail_addr 64> | [add mail_receiver <mail_addr
64> | delete mail_receiver <index 1-8>]}
show smtp
smtp send_testmsg
Each command is listed, in detail, in the following sections.
enable smtp
Purpose Used to enable the Switch as a SMTP client.
Syntax
enable smtp
Description This command, in conjunction with the disable smtp command
will enable and disable the Switch as a SMTP client without
changing configurations.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable SMTP on the Switch.
DES-3028:4#enable smtp
Command: enable smtp
Success.
DES-3028:4#
disable smtp
Purpose Used to disable the Switch as a SMTP client.
Syntax
disable smtp
Description This command, in conjunction with the enable smtp command
will enable and disable the Switch as a SMTP client without
changing configurations.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable SMTP on the Switch.
DES-3028:4#disable smtp
Command: disable smtp
Success.
DES-3028:4#