D-Link DES-3052P - Page 269

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
264
config gratuitous_arp periodical_send
Purpose Used to configure the interval for periodical sending of gratuitous ARP
request packets.
Syntax
config gratuitous_arp send periodically ipif <ipif_name 12> interval
<value 0-65535>
Description This command is used to configure the interval for periodical sending of
gratuitous ARP request packets. By default, the interval is 0.
Parameters
<ipif_name 12>  Interface name of L3 interface.
<value 0-65535>  Periodically send gratuitous ARP interval time in
seconds. 0- means it will not send gratuitous ARP periodically.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure gratuitous ARP intervals for the IPIF System:
DES-3028P:4#config gratuitous
_
arp send periodically ipif System
interval 5
Command: config gratuitous
_
arp send periodically ipif System
interval 5
Success.
DES-3028P:4#
enable gratuitous_arp trap and log
Purpose Used to enable the gratuitous ARP trap and log.
Syntax
enable gratuitous_arp {ipif <ipif_name 12>} {trap |log}
Description The command is used to enable gratuitous ARP trap and log states. The
switch can trap and log the IP conflict event to inform the administrator.
By default, the trap is disabled and event log is enabled.
Parameters
<ipif_name 12>  Interface name of L3 interface.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable the System’s interface gratuitous ARP log and trap:
DES-3028P:4#enable gratuitous_arp System trap log
Command: enable gratuitous_arp System trap log
Success.
DES-3028P:4#
disable gratuitous_arp trap and log
Purpose Used to disable the gratuitous ARP trap and log.
Syntax
disable gratuitous_arp {ipif <ipif_name 12>} {trap |log}
Description The command is used to disable the gratuitous ARP trap and log states.
The switch can trap and log the IP conflict event to inform the
administrator. By default, the trap is disabled and event log is enabled.
Parameters
<ipif_name 12>  Interface name of L3 interface.