D-Link DES-3052P - Page 306

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
301
config lldp dot3_tlvs
disable .
Restrictions Only Administrator-level users can issue this command.
Example usage
To configure the MAC/PHY configuration/status TLV from the outbound LLDP advertisements for all ports:
DES-3028P:4#config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Command: config lldp ports all dot3_tlvs
mac_phy_configuration_status enable
Success.
DES-3028P:4#
config lldp forward_message
Purpose Used to configure forwarding of lldpdu packet when LLDP is disabled.
Syntax
config lldp forward_message [enable | disable]
Description When lldp is disabled and lldp forward_message is enabled, the
received LLDPDU packet will be forwarded. The default state is disable.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage
To configure the LLDP forward_lldpdu:
DES-3028P:4# config lldp forward_ message enable
Command: config lldp forward_ message enable
Success.
DES-3028P:4#
show lldp
Purpose This command displays the switch’s general LLDP configuration status.
Syntax
show lldp
Description This command displays the switch’s general LLDP configuration status.
Parameters None.
Restrictions None.