D-Link DES-3052P - Page 324

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
319
config address_binding ip_mac ports
Syntax
config address_binding ip_mac ports [<portlist> | all] allow_zeroip
[enable|disable]
Description This command will configure IP-MAC state to enable or disable for specified
ports.
Parameters
<portlist>  Specifies a port or range of ports.
all – specifies all ports on the switch.
allow_zeroip [enable | disable] – Enables or disables zero IP address.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure address binding on the Switch:
DES-3028P:4#config address
_
binding ip
_
mac ports 2
allow_zeroip enable
Command: config address
_
binding ip
_
mac ports 2
allow_zeroip enable
Success.
DES-3028P:4#
config address_binding ip_mac ports
Purpose Used to configure an IP-MAC state to enable or disable for specified ports.
Syntax config address_binding ip_mac ports [<portlist> | all] forward_dhcppkt
[enable | disable]
Description This command will configure IP-MAC state to enable or disable forward
DHCP packet for specified ports.
Parameters
<portlist>  Specifies a port or range of ports.
all – specifies all ports on the switch.
forward_dhcppkt [enable | disable] – Enables or disables forward DHCP
packet. By default, the DHCP packet with broadcast DA will be flooded.
When set to disable, the broadcast DHCP packet received by the specified
port will not be forwarded. This setting is effective when DHCP snooping is
enabled, under which case the DHCP packet which has been trapped to
CPU needs to be forwarded by the software. This setting controls the
forwarding behavior under this situation
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure address binding on the Switch: