D-Link DES-3052P - Page 56

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
51
config snmp system_location
string is accepted if there is no location desired.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the Switch location for “
HQ 5F ”:
DES-3028P:4#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DES-3028P:4#
config snmp system_name
Purpose Used to configure the name for the Switch.
Syntax
config snmp system_name {<sw_name>}
Description The config snmp system_name command configures the name of
the Switch.
Parameters
<sw_name>  A maximum of 128 characters is allowed. A NULL
string is accepted if no name is desired.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the Switch name for “DES-3028P Switch
”:
DES-3028P:4#config snmp system_name DES-
3
028P
Switch
Command: config snmp system_name DES-3028P Switch
Success.
DES-3028P:4#
enable rmon
Purpose Used to enable RMON on the Switch.
Syntax
enable rmon
Description This command is used, in conjunction with the disable rmon
command below, to enable and disable remote monitoring (RMON)
on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example Usage:
To enable RMON: