4 Configuration D-Link Smart Managed Switch User Manual
22
Warmstart
Check this feature to have client devices send an SNMP
notification to the management station when performing a
warm start.
Table 4.8
Click Apply to make the configurations take effect.
Management > SNMP > SNMP Community Table Settings
This SNMP Community Table Settings page is used to create an SNMP community string to define the
relationship between the SNMP manager and an agent. The community string acts like a password to permit
access to the agent on the Switch.
Figure 4.22 –Management > SNMP > SNMP Community Table Settings
The fields that can be configured for SNMP Community Settings are described below:
Item Description
Access Right
Select the access right here. Options to choose from are Read
Only, and Read Write.
Read Only - SNMP community members can only read the
contents of the MIBs on the Switch.
Read Write - SNMP community members can read from, and
write to the contents of the MIBs on the Switch.
Community Name
Enter an alphanumeric
string of up to 16 characters that is
used to identify members of an SNMP community. This string
is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
Table 4.9
Click Apply to create a new SNMP community.
Management > SNMP > SNMP Host Settings
This SNMP Host Settings page is used to configure the recipients of the SNMP notifications.
Figure 4.23 – Management > SNMP > SNMP Host Settings
The fields that can be configured for SNMP Host Settings are described below:
Item Description
Host IPv4 Address Specify the IPv4 address of the SNMP management host.
User-
Model
Specify the security model. The options to choose from are
SNMPv1 and SNMPv2c.
To Next Page
Loading...
Need help?
General