4 Configuration D-Link Smart Managed Switch User Manual
24
L2 Features > FDB > Static FDB > Multicast Static FDB
The Multicast Static FDB page allows user to view and configure the static multicast forwarding settings on
the Switch.
Figure 4.26 – L2 Features > FDB > Static FDB > Multicast Static FDB
The fields that can be configured for Multicast Static FDB are described below:
Item Description
From Port / To Port Enter the appropriate port range used for the configuration.
VID
Enter the VLAN ID of the VLAN the corresponding MAC address
belongs to.
MAC Address
Enter the static destination MAC address of the multicast packets.
This must be a multicast MAC address. The format of the
destination MAC address is 01-XX-XX-XX-XX-XX.
Table 4.13
Click Apply to make the configurations take effect.
Click Delete All to delete all the entries found in the display table.
Click Delete to remove a specific entry.
L2 Features > FDB > MAC Address Table Settings
The MAC Address Table Settings page allows user to view and configure the MAC address table’s global
settings.
Figure 4.27 – L2 Features > FDB > MAC Address Table Settings
The fields that can be configured for MAC Address Learning are described below:
Item Description
From Port / To Port Enter the appropriate port range used for the configuration.
State
Use the drop-down menu to toggle between Enabled and
Disabled. Default is Disabled.
Table 4.14
Click Apply to make the configurations take effect.
To Next Page
Loading...
