D-Link DGS-1210-10P - Show Switch; Config Account Admin Password

6 Command Line Interface D-Link Web Smart Switch User Manual
96
IP Setting Mode : Static
IP Address : 10.90.90.90
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
DHCPv6 Client State : Disabled
IPv6 Global Unicast Address: 3ffe:501:ffff:100:100::1/64
DGS-1210-52>
show switch
Purpose To display information about the Switch.
Syntax
show switch
Description
The show switch command displays the status of the switch.
Parameters None.
Restrictions None.
Example usage:
To display the switch information:
DGS-1210-52> show switch
System Name :
System Contact :
System Location :
System up time : 0 days, 6 hrs, 32 min, 17 secs
System Time : 02/01/2012 06:32:19
System hardware version : B1
System firmware version : 3.10.006
System boot version : 1.00.005
System Protocol version : 2.001.004
System serial number : 1MB1733K0000A
MAC Address : 00-01-02-03-04-05
DGS-1210-52>
config account admin password
Purpose To display the configuration of an IP interface on the Switch.
Syntax
config account admin password <pas s wd>
Description
The config account admin pass word command
sets the
administrator password.
Parameters
<passwd> − The new password of the administrator.
Restrictions None.