DGS-1250 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide
26
5. Web-based Switch Configuration
Introduction
Logging into the Web UI
Web User Interface (Web UI)
Introduction
Most software functions of the Switch can be managed, configured, and monitored via the embedded HTML Web UI.
Management can be done on the Switch from remote stations anywhere on the network through a standard web
browser. The web browser acts as a universal access tool and can communicate directly with the Switch using the
HTTP or HTTPS (SSL) protocol.
The following web browsers are supported:
• Internet Explorer (version 8 and later)
• Firefox
• Google Chrome
• Safari
Logging into the Web UI
To access the Web UI, open a standard web browser, enter the Switch’s IP address into the address bar of the
browser, and press the ENTER key.
NOTE: The default IP address of this switch is 10.90.90.90, with a subnet mask of 255.0.0.0.
5-1 IP address in Internet Explorer
NOTE: The default username is admin and the default password is admin.
After pressing the ENTER key, the following authentication window should appear, as shown below.
To Next Page
Loading...
