DGS-1250 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide
8
Figure 1-1 Front panel view of the DGS-1250-28X
Figure 1-2 Front panel view of the DGS-1250-28XMP
Figure 1-3 Front panel view of the DGS-1250-52X
Figure 1-4 Front panel view of the DGS-1250-52XMP
Ports
Ports that can be found on the front panel of this switch are listed in the table below.
Port Description
Console
The RJ45 console port can be used to connect to the Command Line Interface
(CLI) of the Switch for configuration, management, and monitoring. This port uses
a special console cable (included in this package) with a DB9 interface to connect
the Switch to the serial port (COM) of the PC.
10/100/1000 Mbps RJ45
Ports
The DGS-1250-28X and DGS-1250-52X Switches are equipped with 24 or 48 RJ45
Ethernet ports. These ports can operate at 10 Mbps, 100 Mbps, and 1 Gbps wire-
speeds.
10/100/1000 Mbps RJ45 PoE
Ports
The DGS-1250-28XMP and DGS-1250-52XMP Switches are equipped with 24 or
48 RJ45 PoE Ethernet ports. These ports can operate at 10 Mbps, 100 Mbps, and
1 Gbps wire-speeds.
10 Gigabit SFP/SFP+ Ports
The Switch is equipped with 4 SFP/SFP+ ports. These ports can operate at 1
Gbps and 10 Gbps wire-speeds and support a wide collection of SFP/SFP+
transceivers.
For a complete list of SFP/SFP+ transceivers that are compatible with this switch, refer to the SFP+/SFP Ports
section in Appendix A - Technical Specifications.
To Next Page
Loading...
