D-Link DGS-3000 series - Page 46

DGS-3000 Series Gigabit Ethernet Switch Hardware Installation Guide
42
Feature
Description
 Support Auto-negotiation for full-duplex and flow control
operations
SFP Transceivers Supported:
 DEM-302S-LX (1000BASE-LX, Single-mode, 2km)
 DEM-310GT (1000BASE-LX, Single-mode, 10km)
 DEM-311GT (1000BASE-SX, Mutli-mode, 550m)
 DEM-312GT2 (1000BASE-SX, Multi-mode, 2km)
 DEM-314GT (1000BASE-LHX, Single-mode, 50km)
 DEM-315GT (1000BASE-ZX, Single-mode, 80km)
 DGS-712 (1000BASE-T Copper SFP, 100m)
WDM Transceivers Supported:
 DEM-302S-BXD/BCU (1000BASE-BX, Single-mode, 2km)
 DEM-330T/R (1000BASE-BX, Single-Mode, 10km)
 DEM-331T/R (1000BASE-BX, Single-Mode, 40km)
SFP+ Ports
Compliant with the following standards:
 IEEE 802.3ae compliance
 IEEE 802.3z compliance
SFP Transceivers Supported:
 All SFP and WDM transceivers listed in the SFP Ports section
(above) will also work in the SFP+ ports.
SFP+ Transceivers Supported:
 DEM-431XT-DD (10GBASE-SR, 80m: OM1 & OM2 MMF, 300m:
OM3 MMF)
 DEM-431XT (10GBASE-SR (w/o DDM), 80m: OM1 & OM2 MMF,
300m: OM3 MMF)
 DEM-432XT-DD (10GBASE-LR, 10km)
 DEM-432XT (10GBASE-LR (w/o DDM), 10km)
 DEM-433XT-DD (10GBASE-ER, 40km)
 DEM-433XT (10GBASE-ER (w/o DDM), 40km)
 DEM-434XT (10GBASE-ZR (w/o DDM),
 DEM-436XT-BXU (10GBASE-LR BiDi (w/o DDM), 20km, TX:
1270nm, RX: 1330nm)
 DEM-436XT-BXD (10GBASE-LR BiDi (w/o DDM), 20km, TX:
1330nm, RX: 1270nm )
Direct Attached Cables (DAC) with built-in transceivers:
 DEM-CB100S (10G, SFP+ to SFP+, DAC, 1m)
 DEM-CB300S (10G, SFP+ to SFP+, DAC, 3m)
 DEM-CB700S (10G, SFP+ to SFP+, DAC, 7m)
PoE Ports
(DGS-3000-28LP and DGS-3000-
28XMP Only)
 Supports IEEE 802.3af PoE and IEEE 802.3at PoE+ compliance
 Supplies power (ports 1 to 24) to PD devices up to 15.4 Watts
per port (802.3af) or 30 Watts per port (802.3at) and more
sufficiently is able to provide power to PD devices.