DGS-3224TG Gigabit Ethernet Switch User’s Guide
Figure 7-30. Rx Packets Analysis window for UMB_cast (Table)
The information is described as follows:
• Time Interval – Select the desired setting between 1s and 60s, where “s” stands for seconds.
• Record Number – Select number of times the switch will be polled between 20 and 200.
• Multicast – Counts the total number of good packets that were received by a multicast
address.
• Broadcast – Counts the total number of good packets that were received by a broadcast
address.
• Unicast – Counts the total number of good packets that were received by a unicast address.
• Show/Hide – Check whether or not to display Multicast, Broadcast, and Unicast Packets.
• Clear – Clicking this button clears all statistics counters on this window.
• View Table – Clicking this button instructs the switch to display a table rather than a line
graph.
• View Line Chart – Clicking this button instructs the switch to display a line graph rather than a
table.
106
To Next Page
Loading...
