D-Link DGS-3224TG - Use Configuration File on TFTP Server

DGS-3224TG Gigabit Ethernet Switch User’s Guide
Figure 6-46. Upgrade Firmware screen
Enter the IP address of the TFTP server in the Server IP Address field.
Note: The TFTP server must be on the same IP subnet as the switch.
Enter the path and the filename to the firmware file on the TFTP server.
Note: The TFTP server must be running TFTP server software to perform the file transfer. TFTP
server software is a part of many network management software packages, or can be
obtained as a separate program.
Highlight APPLY and press Enter to record the IP address of the TFTP server. Use Save Changes from
the main menu to enter the address into NV-RAM
Highlight START and press Enter to initiate the file transfer.
Use Configuration File on TFTP Server
To download a switch configuration file from a TFTP server, highlight Use a Configuration File on
TFTP Server and press Enter.
71