DGS-3224TG Gigabit Ethernet Switch User’s Guide
• A 10BASE-T hub or switch can be connected to the switch via a two-pair Category 3, 4, 5, or 5e
UTP/STP cable.
• A 100BASE-TX hub or switch can be connected to the switch via a two-pair Category 5 or 5e
UTP/STP cable.
• A 1000BASE-T switch can be connected to the switch via four-pair straight Category 5 or 5e
UTP/STP cable.
Figure 4-2. Switch connected to a normal (non-Uplink) port on a hub or switch using a straight or crossover
cable
10
To Next Page
Loading...
