DGS-3224TG Gigabit Ethernet Switch User’s Guide
Setting-up STP using values other than the defaults can be complex. Therefore, you are advised to keep
the default factory settings and STP will automatically assign root bridges/ports and block loop
connections. Influencing STP to choose a particular switch as the root bridge using the Priority setting,
or influencing STP to choose a particular port to block using the Port Priority and Port Cost settings
is, however, relatively straight forward.
Figure 5-4. Before Applying the STA Rules
In this example, only the default STP values are used.
Figure 5-5. After Applying the STA Rules
21
To Next Page
Loading...
