D-Link DHP-1320 - Page 80

75D-Link DHP-1320 User Manual
Section 3 - Conguration
IPv6
6to4 - Stateful
To congure the Router to use an IPv6 to IPv4 tunnel stateful autoconguration connection, congure the parameters in the
LAN Address Autoconguration Settings section as described below:
Check to enable the Autoconguration feature.
Select the Stateful option from the drop-down menu.
Enter the start IPv6 Address for the DHCPv6 range for
your local computers.
Enter the end IPv6 Address for the DHCPv6 range for
your local computers.
Enter the IPv6 Address Lifetime (in minutes).
Enable automatic
IPv6 address
assignment:
Autoconguration
Type:
IPv6 Address
Range Start:
IPv6 Address
Range End:
IPv6 Address
Lifetime:
Click the Save Settings button to save any changes made.