D-Link DHP-P610AV

23D-Link DHP-W611AV User Manual
Section 3 - Conguration
System
Save Settings To
Local Hard Drive:
Load Settings
From
Local Hard Drive:
Restore to
Factory Default
Settings:
Reboot the
Device:
Use this option to save the current DHP-W610AV conguration
settings to a le on the computer you are using. Click the Save
button. You will then see a le dialog where you can select a
location and le name for the settings.
Use this option to load previously saved DHP-W610AV
conguration settings. Click Browse to nd a previously
saved conguration le. Then, click the Upload Settings
button to transfer those settings to the DHP-W610AV.
This option will restore all conguration settings back to the
settings that were in eect at the time the DHP-W610AV was
shipped from the factory. Any settings that have not been
saved will be lost, including any rules that you have created. If
you would like to save the current DHP-W610AV conguration
settings, use the Save button above.
Click to reboot the DHP-W610AV.
This page lets you both save and update the settings of your DHP-W610AV.