D-Link DIR-412 - Firewall Rules Configuration

50D-Link DIR-412 User Manual
Section 3 - Conguration
Firewall Rules
Enter a name for the rewall rule.
Use the drop-down menu to specify if the router should Allow or Deny
trac matching the rewall rule.
Use the drop-down menus to select the Source and Destination
interfaces for the Firewall Rule
Use the IP Address elds next to each Interface drop-down menu to
specify the IP address ranges for the Source/Destination interfaces.
The rst host in the IP address range should be entered in the top eld
and the last host in the IP address range should be entered in the eld
beneath for both the Source/Destination intefaces.
Use the drop-down menu to select the protocol that will be used for
the rewall rule (TCP, UDP, ICMP, or ALL).
Enter the range of ports that the rewall rule will apply to.
The rst port in the port range should be entered in the top eld and
the last host in the port range should be entered in the eld beneath.
Use the drop-down menu to select the schedule for the Network
Filter rule. Click the New Schedule button to bring up the “Schedule
Webpage” to congure the new schedule.
Name:
Action:
Interface:
Protocol:
Port Range:
Schedule:
To create a rewall rule, congure the parameters as described below: